compaqdrew
01-27-2008, 09:54 AM
## Automatic notice to thread opener:
If you post this kind of message into the News Category again, your Account will be disabled
I picked up a NetworkEverywhere NC100U-WM from wal-mart, as my onboard nForce ethernets don't work. The card has been working with Tulip in the past.
I compiled Tulip with XCode on my real Mac, then loaded it. It seems to run ok, I get a message at boot:
darwin_tulip_admtek985: Ethernet address: BLAH
Yet it doesn't show up in network preferences. Any thoughts?
--Drew
If you post this kind of message into the News Category again, your Account will be disabled
I picked up a NetworkEverywhere NC100U-WM from wal-mart, as my onboard nForce ethernets don't work. The card has been working with Tulip in the past.
I compiled Tulip with XCode on my real Mac, then loaded it. It seems to run ok, I get a message at boot:
darwin_tulip_admtek985: Ethernet address: BLAH
Yet it doesn't show up in network preferences. Any thoughts?
--Drew