PDA

View Full Version : USB Wireless Adapter


jshanh
01-12-2008, 10:34 PM
Has anyone had any results in getting a USB wireless adapter to work?
Ive researched this alot and it looks like my Dynex USB adapter is not supported
by any third party osx86 drivers or anything. Its recognized fine in my System Profiler as:

802.11b/g LP/SC USB:

Version: 0.01
Bus Power (mA): 500
Speed: Up to 12 Mb/sec
Manufacturer: Broadcom
Product ID: 0x0721
Serial Number: 43860000
Vendor ID: 0x4317

Is there any Kexts I could put the device id into?
Its a broadcom chipset like the aiport cards so I think it may work, I just dont know what kext to
manipulate to get this to work. Any suggestions would be great. Thanks.

AMD Athlon 64 3200
MOBO: Biostar 6100 Nforce430/410
Seagate PATA HDD 160gigs
1 gig kensington ram, 2x512
AC97 Audio

jshanh
01-15-2008, 12:00 AM
Anyone?

benzene
01-20-2008, 02:25 AM
You could give kismac a try to check out if itīs possible to communicate to your card with its built in drivers.
I donīt know much about broadcom chipsets.
I know Ralink and prism2 chipsets work quite good on real macs and osx86 machines too.

zephyroth
01-21-2008, 12:13 AM
Broadcom 43xx, Ralink rt2500 and Ralink rt73 are included in Rev.2

sbisbilo
12-17-2009, 04:44 PM
Ca veut dire quoi zephroth?
J'ai une carte pci ā base de RT2500, ca fonctionnera nativement sous SL?
Merci

Broadcom 43xx, Ralink rt2500 and Ralink rt73 are included in Rev.2

Keagi
12-17-2009, 04:57 PM
I use a Belkin Wireless G USB adapter which works perfectly w/ Ralink drivers :o