I'm using an XFX nForce 750a with Phenom Quad and I had to install it on my wife's machine, add my IDE DEV's numbers, cos all's I would get was still waiting for root device. . .

Once I did that, it was a breeze.

Using iPC 10.5.6 and installed the following drivers:
Video: (using GeForce 7300GS) and NVinject for dual monitors
Sound: Realtek ALC1200 (AppleAzaliaAudio) here (if insanelymac isn't down)
LAN: Onboard Yukon Marvell 88E8056 driver

for IDE to work I had to manually add 0x075910de to AppleVIAATA.kext (Because nforce driver says it didn't like it) after fixing permissions. For the SATA drives you just have to change the setting in CMOS from SATA to AHCI.

I still need the sound driver if you got one, I'd really appricate it!
InsanelyMac has been down now for a while, that's where I got it before. . .

I'm using the exact same setup, XFX nForce 750a with AMD Phenom
I had to put my IDE DVD drive as master and then I could boot fine with some distros like iAtkos 10.5.7 and some others I forget. . .

The drivers you want to use are listed in this post:
http://www.insanelymac.com/forum/ind...owtopic=172553

just make sure your SATA settings in BIOS are set to AHCI

The drivers I'm using are:
Onboard LAN: Yukon88E8056
Onboard Sound: VoodooHDA
GeForce 7300GS: NVinject
HardDrives: ahci.pkg & genericata.pkg from iAtkos 10.5.7

note: I'm actually running retail now from a boot132 so I can update with no hassles. . .

ptesone do you have the boot 132 you used?

HI,
I have used iDeneb on a similar system (my MB is ASUS 750a SLi and i have Phenom II 940 BE)
my only problem was that my cd drive was at the slave (second port in IDE)
when i used master, it worked!