infinitelylooping
08-10-2010, 01:35 PM
After hours of work, finally got the iAtkos 7 dvd booting up (I have had a successful install on a previous system) - I used "busratio=31 -v", however I noticed that during the verbose boot I could see that it was saying;
disk 0 s1 cannot mount
disk 0 s2 cannot mount
etc (from memory, not exactly like that)
But i didn't think anything of it.
Then when i went in to format my fat32 partition to HFS Journalled disk utility wouldn't do it, and then i tried mounting the other drives, and none of them would mount. Tried doing the repair thing, no luck.
Even trying to mount a drive from the same hdd i used in my last systems install didnt work.
My setup is
160gb: Win7, Leopard, Blank Space
1tb: my data
I have tried in ahci and ide modes.
Solved with this: http://www.insanelymac.com/forum/index.php?showtopic=226621&st=0
disk 0 s1 cannot mount
disk 0 s2 cannot mount
etc (from memory, not exactly like that)
But i didn't think anything of it.
Then when i went in to format my fat32 partition to HFS Journalled disk utility wouldn't do it, and then i tried mounting the other drives, and none of them would mount. Tried doing the repair thing, no luck.
Even trying to mount a drive from the same hdd i used in my last systems install didnt work.
My setup is
160gb: Win7, Leopard, Blank Space
1tb: my data
I have tried in ahci and ide modes.
Solved with this: http://www.insanelymac.com/forum/index.php?showtopic=226621&st=0