Stop sign on the gray apple screen, Two weeks of pain

[josephrave]

Hi Guys,

I desperately need your help :(

I've been trying to install a retail Mac 10.5.6 for two weeks already. I tried different kinds of boot loaders but I can't progress any further on a gray apple screen with a stop sign.

Here is my laptop specs:

Processor: Intel® Celeron Processor M900
(1 MB L2 cache, 2.2 GHz, 800 MHz FSB)

Chipset: SiS M672 + SiS 968
Memory: 2GB DDR2
upgradeable to 2GB with discard

Display Screen: 14.1" WXGA TFT LCD
(1280 x 800 pixel resolution)

Video Type: SiS Mirage 3+
Hard Disk:160 GB SATA HDD
Optical Drive: Built-in DVD-RW Multi-Drive
Weight 2.3 kg
Card Reader: 4-in-1 Card Reader
Operating System: Free DOS
Productivity Software: None
Network Interface: Built in 56k Modem, Built in 10/100 LAN
Wireless LAN: Integrated 802.11 b/g wireless LAN
WebCam: Neo Motion Eye 1.3 Megapixel
Battery: 6 Cells (2.0-3.0Hours battery life)
I/O Ports: 3 x USB, 1 x VGA port, Express Card 54 slot, S-video/TV-out (NTSC/PAL) port


Here are the boot loaders that I've tried:
asus_p5w-dh_boot-132.iso
BOOT-KABYL-BUMBY
ga-ep45-ds3r_boot132.iso
grub-dfe.iso
LegacyBootCD.iso
osx86svboot.iso

[josephrave]

After spending some time researching I have found something that might help also help

Thanks to Voyn1x of infinitemac

Here are the solutions that I found in his website:


Solution 1 - change drive to primary

The most common solution is making your OSX drive the primary IDE. Try disconnecting all the other hard drives, make the OSX drive IDE0, using either cable-select or Master jumper settings.

In some cases forced or strange IDE master/slave settings can cause problems. For instance, on one system setting the DVD drive via jumpers as the slave drive but attaching it as the only device to the end of the cable can cause this problem. Reconfiguring the drive to use cable select (it then chose to be the master drive) fixed the problem.

Solution 2 - specify the boot disk

Code: rd=diskXsY -v X and Y are just placeholders and need to be replaced with proper values. X is the disk number (on most systems installed to the first hard disk, this will be disk0) and Y the partition number.

Solution 3 - use an IDE drive

Use an IDE drive or alternatively try and patch the install dvd with the correct SATA chipset driver for your hardware.

Solution 4 - use a SATA optical drive

For newer Intel chipsets such as the 965 that do not natively support IDE (and use chips such as JMicron or Marvell), use a SATA optical drive.

Solution 5 - try different boot options

Code: platform=X86PC -v

platform=ACPI -v

-x -v

-f -v

[Averna]

Ok I Tried ALl The ABove But I Still Has The Problem
I have
acer aspire 5536 and it have AMD Athleon 64 X2 And IDE 320gb western which its IDE0
and Bios is set to IDE mode and in install i choosed generic ide 9.5.0 voodoo kernel
voodoo ps2 mouse driver
and when i run those commands in verbose mode i stuck at BSD Auditing Present
And Nothing Goes Further
So Any Suggestion ?