Problem Installing with iATKOS
I was successful in getting the DVD to boot up, and format my partition as Extended Journaled, but I encountered a few problems, chiefly among them when I went Utilities, there was no option called "Darwin Boot" As I said the install was…
- Primary Author
- @SkaWes Published 2009-03-30
- Collection
- Leopard 10.5
- Archival Footprint
- 4,408 historical reads · 1 curated field notes (from 4 dispatches) · 2009-03-30 – 2009-03-31
- Credited Voices (2)
- @SkaWes (2)@lanceomni (2)
I was successful in getting the DVD to boot up, and format my partition as Extended Journaled, but I encountered a few problems, chiefly among them when I went Utilities, there was no option called "Darwin Boot"
As I said the install was successful, but when I boot the computer up it boots straight in to Vista. What can I do to remedy this situation?
Author Updates & Technical Revisions
Follow-up dispatches by @SkaWes
Well now I am not sure what to do, when I boot from the CD it will not load in to the installation setup. If I just hit enter when prompted it goes to the apple logo and hangs there, if I type in -v it goes through a few lines of text that fills the screen, and then hangs there as well.
Synthesized Community Field Notes
1 technical responses curated from 4 original dispatches
If your install is on a separate drive you should be able to set boot order in your BIOS or by pressing the function key associate with boot order on startup.
If you install is on a partition you have two options.
1. Boot using the rd=diskXsY option where X is the disk number (starting with 0) and Y is the partition.
2. Boot using the partitions UUID (boot-uuid=F2E496ED-4FB6-3277-B24B-92B648D6006E)
Both of these can be found by booting the install disk, opening Disk Utility and selecting Information on the partition you installed to.
You use these commands at the Darwin prompt. Most likely since you go straight to Vista you do not get the prompt. You can instead boot the Install disk but when the Darwin prompt comes up you may use the commands.
Should look something like this. Ive added -v Verbose mode option as you should be using this every time you boot.
-v rd-disk0s1
-v boot-uuid=F2E496ED-4FB6-3277-B24B-92B648D6006E
Sources & Contributor Provenance (2 credited usernames · Thread #2465)
| Username | Dossier Contribution | Dispatches | Active Window |
|---|---|---|---|
| @SkaWes | Primary Author | 2 | 2009-03-30 → 2009-03-31 |
| @lanceomni | Contributor | 2 | 2009-03-30 → 2009-03-31 |