Problems in Snow Leopard A394
I have installed Snow Leopard 10A380. After 10A394 update on software update I can no longer use the Internet. I use the Internet to AppleYukon2 to come. What can I do to make my internet working again? Next problem is with my GTX260. I…
- Primary Author
- @xBattleFreakx Published 2009-08-11
- Collection
- OSx86 Core & 10.X
- Archival Footprint
- 4,383 historical reads · 3 curated field notes (from 7 dispatches) · 2009-08-11 – 2009-08-14
- Credited Voices (2)
- @xBattleFreakx (4)@DocShadow (3)
I have installed Snow Leopard 10A380. After 10A394 update on software update I can no longer use the Internet. I use the Internet to AppleYukon2 to come. What can I do to make my internet working again?
Next problem is with my GTX260. I can not in 64 bit mode. Screen stays black. 32-bit works.
Please understand my bad English!
HW:
Asus Maximus II Formula
Q2D Q6600 @ 2,4 GHz
1066 MHz OCZ Reaper
Palit GTX 260 Sonic 216SP
Author Updates & Technical Revisions
Follow-up dispatches by @xBattleFreakx
what should I change at the com.apple.boot.plist or register? I have such files has never been edited. in mac 10.5.8 I have no such problems.
Thanks for the help. I can now start in 64bit. However, I have now the problem is that my network does not work. Use AppleYukon2. Can you help me with this problem?
I have a forum thread found, where a AppleYukon2.kext published. This works for me. I can now snow leopard in 64 bit advantage.
Unfortunately, I do not know if I left here to other sites may post.
LG
Synthesized Community Field Notes
3 technical responses curated from 7 original dispatches
I assume you are using a kext for the GTX260.
Trying using the device properties string in the com.apple.boot.plist instead.
@xBattleFreakxwhat should I change at the com.apple.boot.plist or register? I have such files has never been edited. in mac 10.5.8 I have no such problems.
That's because your kext is 32 bit. SL in 64 bit mode ingnores any 32 kexts so you either need to get the 64 bit version of the kext or modify the plist with your specific device string.
Check OSXTools to see if it lists your video card. If so, then you can pull the string off from there.
I would not know ... I use skge for the Marvel Yukon controllers on my P5Q but that's a 32 bit kext.
My SL board uses RTL.
Sources & Contributor Provenance (2 credited usernames · Thread #3612)
| Username | Dossier Contribution | Dispatches | Active Window |
|---|---|---|---|
| @xBattleFreakx | Primary Author | 4 | 2009-08-11 → 2009-08-14 |
| @DocShadow | Core Contributor | 3 | 2009-08-13 → 2009-08-14 |