Stop sign on the gray apple screen, Two weeks of pain

After spending some time researching I have found something that might help also help

Thanks to Voyn1x of infinitemac

Here are the solutions that I found in his website:

Solution 1 - change drive to primary

The most common solution is making your OSX drive the primary IDE. Try disconnecting all the other hard drives, make the OSX drive IDE0, using either cable-select or Master jumper settings.

In some cases forced or strange IDE master/slave settings can cause problems. For instance, on one system setting the DVD drive via jumpers as the slave drive but attaching it as the only device to the end of the cable can cause this problem. Reconfiguring the drive to use cable select (it then chose to be the master drive) fixed the problem.

Solution 2 - specify the boot disk

Code: rd=diskXsY -v X and Y are just placeholders and need to be replaced with proper values. X is the disk number (on most systems installed to the first hard disk, this will be disk0) and Y the partition number.

Solution 3 - use an IDE drive

Use an IDE drive or alternatively try and patch the install dvd with the correct SATA chipset driver for your hardware.

Solution 4 - use a SATA optical drive

For newer Intel chipsets such as the 965 that do not natively support IDE (and use chips such as JMicron or Marvell), use a SATA optical drive.

Solution 5 - try different boot options

Code: platform=X86PC -v

platform=ACPI -v

-x -v

-f -v

Still Has Problem

Ok I Tried ALl The ABove But I Still Has The Problem
I have
acer aspire 5536 and it have AMD Athleon 64 X2 And IDE 320gb western which its IDE0
and Bios is set to IDE mode and in install i choosed generic ide 9.5.0 voodoo kernel
voodoo ps2 mouse driver
and when i run those commands in verbose mode i stuck at BSD Auditing Present
And Nothing Goes Further
So Any Suggestion ?