Tulip.kext
## Automatic notice to thread opener: If you post this kind of message into the News Category again, your Account will be disabled I picked up a NetworkEverywhere NC100U-WM from wal-mart, as my onboard nForce ethernets don't work. The card…
- Primary Author
- @compaqdrew Published 2008-01-27
- Collection
- Leopard 10.5
- Archival Footprint
- 6,153 historical reads · 1 curated field notes (from 2 dispatches) · 2008-01-27
- Credited Voices (2)
- @compaqdrew@roisoft
## Automatic notice to thread opener:
If you post this kind of message into the News Category again, your Account will be disabled
I picked up a NetworkEverywhere NC100U-WM from wal-mart, as my onboard nForce ethernets don't work. The card has been working with Tulip in the past.
I compiled Tulip with XCode on my real Mac, then loaded it. It seems to run ok, I get a message at boot:
darwin_tulip_admtek985: Ethernet address: BLAH
Yet it doesn't show up in network preferences. Any thoughts?
--Drew
Synthesized Community Field Notes
1 technical responses curated from 2 original dispatches
Open Nerwork preferences and click over "+" and add the ethernet adaptor..
Sources & Contributor Provenance (2 credited usernames · Thread #107)
| Username | Dossier Contribution | Dispatches | Active Window |
|---|---|---|---|
| @compaqdrew | Primary Author | 1 | 2008-01-27 |
| @roisoft | Contributor | 1 | 2008-01-27 |