Quote:
Originally Posted by nismozcar
I have successfully updated to 10.6.7 following this thread's instructions. After the initial Snow Leopard installation, I download and installed the 10.6.4 Combo Update (Followed the guide procedures) and then dowloaded and installed the 10.6.7 Combo Update (Same as 10.6.4). I used the updated NetbookInstaller that was provided for 10.6.4 to install 10.6.7. In order to boot in "recovery=y" I had to hold the SHIFT button after restart, TAB didn't work for me. Thanks for the creating this thread!
|
I can confirm that it works following these directions as well.
I was hitting both shift and tab to be safe.
Also, I have determined that the hissing noise that many are complaining about is due to the input gain in the voodoo preferences. Turn it down, and your set. This gets reset everytime you reboot your computer though.
Last I have had issues since 10.6.1 (or 6.0 not sure at this point) with sleep.... goes into panic, and says something about the ralink driver, so I am just going to look into replacing the wifi card with one that supports airport, seems like it would be a lot easier.
Just glad that I can use xcode 3+ so I can begin learning how to develop for the iPhone (have some java/c experience). Can't afford a mac pro right now as a college student.
I can't thank the community here enough, and especially the OP for all the effort, detail, and help provide to make this as easy as possible for everyone with a 1000HE.
Had to register just to say all that
-Ryan