 |
|
#1
12-25-2009, 10:17 PM
|
|||
|
|||
|
Not booting after instalation
DELL XP 400 I have installed ideneb 10.5.7 was running good but I installed windows over it by mistake and restore my bios to factory defaults now when I try to reinstall again the installation goes fine and after restart only apple logo no smoke ring, I have two HD installed one has windows 7. processor Intel p 4 cache 1MB 0r 2 MB memory 4 GB chipset intel 945P bioss chip (NVRAM) 4MB Thanks 
|
|
#2
12-30-2009, 02:09 AM
|
|||
|
|||
|
Did you made the selection of one of the included patched Kernels?
AMD Phenom II X4 955 - ASRock AM3A770DE - 8GB DDR3-1333 - Radeon HD 5570 1GB passiv - BCM4318 802.11b/g - Snow Leopard Retail
+++ AMD Phenom X3 8450 - ASRock AM2NF6G-VSTA (BIOS L2.39) - 4GB DDR2-800 - Radeon HD 4650 512MB - Snow Leopard Retail (retired) / OpenBSD
|
|
#3
02-01-2010, 12:33 AM
|
|||
|
|||
|
You don't have the smoke ring... But does the computer stay on? I have the same issue but the computer goes off... Maybe it's your problem... Anyways, for booting I booted from the CD with the flag rd=disk0s2 (to modify by your installation hard drive). Or if you cannot boot to the CD drive, you could try -v -x. Also, you can modify SATA settings in the bios to AHCI.
💡 Deploy cloud instances seamlessly on DigitalOcean. Free credits ($100) for InfMac readers.
|
 |
Linear Mode
|
|