Has this happened to anybody yet, I have a HP DV2415nr Laptop, 1.8 gig turion x2 processor, broadcom wireless, NVIDA Geforce GO 6150 Graphics. 150 gig SATA Hardrive, 80 gig Maxtor USB Harddrive (Leopard). Ok my question is I go through the installation, select custom, 9.2.0 kernel, MBR-EFI, Broadcom Drive. Deselect, languages and fonts. Installation goes fine till the very end at the point of "about a min", its a half a inch from finishing, but then everything stops. The installation bar, dvd, and harddrive. Mouse still moves but I can't do anything. Ok so I do a cold shutdown. And then restart, I boot from the USB Harddrive and the Bootloader comes up and starts to load up leopard, And it comes up and everything seems ok. My question is as in 10.5.1 by zeph it freezing at about a min to go was a known issue and the solution was to go back into the installer not changing anything and letting it install the missing files. I didn't do that in 10.5.2 since it loaded. Should I go back and do that? Thanks.