First thing i want to say is, thank's to all that have contributed to this thread.

Second thing i thought i might post how i set it all up to help others.

So i have a rev.2 board and i brought a http://www.tp-link.com/products/product_des.asp?id=2 to replace the on board network, cost me AU$18 from the local shop its all they had and it had a realtek chip so i brought it, works 100% OOB. Best thing i could of ever done and i recommend you to do the same.

After i did that i install Leopard retail onto the same disk i wanted Snow, but i later just did a clone of that disk onto my usb drives partition and used boot 123 to boot it. I installed Snow following this guide and hit an issue where chameleon wouldn't install, i found a pkg of RC3 and just followed the guide using that instead and it worked fine, im also sticking with the 32bit kernel as vmware wont work otherwise. I also updated to 10.6.1 and not one problem, it even sleeps/wakes automatically. So those are the two minor issues i had and if anyone has the same just do what i did and it should work great.

Now i have one slight problem someone might be able to help me with, i installed synergykm beta 7, it works great but if i reboot the pc it doesn't start up automatically is there some way i can do this? Also with linux when i was using synergy for a keyboard/mouse i would have it automatically login but then lock the screen, so its loged in but still cant be accessed without my password, this is so synergy can load and i can then use the keyboard/mouse from another computer. Is there some way i can do this? If anyone's had any experience with synergy your help would be appreciated, and if you haven't had any experience with synergy, its the best way to share a mouse/kb between computers!

Anyway, thanks a lot for the great guide.