InfiniteMac OSx86
Page 2 of 2 < 1 2
Show 50 post(s) from this thread on one page

InfiniteMac OSx86 (http://infinitemac.com/forum.php)
-   Leopard 10.5 (http://infinitemac.com/forumdisplay.php?f=85)
-   -   OSx86 on Gigabyte GA-MA78GM-S2H ? (http://infinitemac.com/showthread.php?t=1427)

cgsheen 10-15-2008 09:42 PM
Quote:
Originally Posted by FirstHackTosh (Post 17021)
Hi guys,

second question: Now I'm searching for a MacOS X, Vista and XP compatible WLAN PCI(e) card for my FirstHackTosh ;)

Any suggestions?

Thanks in advance
FHT
I have 2 or 3 of these:

http://www.airlink101.com/products/awll3026.php

Bought them for about $8-$10 on sale at Fry's Electronics. I've used them with WinXP, Vista, and OSx86 (10.5.1 through 10.5.4) There are OSX drivers for 10.4 on the website - they work in 10.5.x also.

You might look at their PCI cards - might have OSX drivers for them too...

fgalvani 06-26-2009 02:05 PM
Could you help me ?
 
Hi, I've read this thread and I need some help.
I have the same MB Gigabyte GA-MA78GM-S2H but with AMD Phenom II 920, plus 4Gb RAM DDR2 800Mhz, HD 500GB SATA, DVD-RW LG SATA, Internal USB Card Reader and D-Link DWA-110 USB WiFi.
I've installed Windows XP and everything works fine. Now I want to make a triple boot with Windows XP, Windows 7 (for test propose only) and OSx86.
First of all, I've disconnected the Internal USB Card Reader and D-Link DWA-110 USB WiFi because I want to try first the system OOB. I setup my BIOS to use AHCI mode for the SATA drives.
I've tried to use Leo4All but it didn't load the install. Then I tried iPC OSx86 10.5.6. I've followed the install instructions and I didn't select any optionals. I've formatted my SATA drive as Mac OS journaled and MBR partition map. I've choose the default boot loader (Chameleon 1.0.12). The installation has worked ok and I need to reboot. The boot loader loads and everytime when Darwin starts, my computer reboots !!!
I've tried to set "Graphics Mode"="1024x768x32" but it didn't work.

Anyone could help ? Tks in advance.

Ali C. 06-26-2009 06:23 PM
Try Native IDE. I've had it act fishy under AHCI before, so it's a thought.
As for Phenoms...not to knock things off topic but I was wondering. If you take a perfectly working OSx86 with an X2 (this install is Kalyway, but updated to 10.5.7 + Chameleon bootloader) and swap out the X2 with a Phenom, will it work okay, will it slow down, or will it not work at all and require a full reinstall of LawlessPPC?