bump for an update

thank you, works great, jus wondering, its suppose to work faster, than previous version? what is the main differences between this and older?

The only thing my mod does is correctly detect the FSB speed for AMD Phenoms and Shanghai processors allowing them to run at speeds higher than 3.0 GHz without kernel panic. If you have a Phenom I or II with a clock speed lower than 3.0 GHz and don't overclock, it doesn't really make a difference, but if you're is higher, it will no longer kernel panic at boot-up.

any new patched mach_kernel 10.3.0 ?
 

@ blackknight :

could you build a new patched mach_kernel 10.3.0 for the AMD system ?

fyi, now I'm running the Snow Leo Server 10.6.3 with your latest patched kernel (the blackknight's darwin 10.2.0)

http://i39.tinypic.com/2a66z6d.jpg


thanks for your great efforts :)

Could you please post your system specs? I noticed that you have 64 bit mode working, which I haven't been able to do with snow 10.6.2.

Also, the darwin 10.3.0 kernel sources haven't been posted yet, so we can't make new kernels yet.

thanks for the answer :)

and here is my specs :

- AMD Phenom II x4 965 BE c3
- Biostar TA790GX A3+
- 2X2GB OCZ AMD Platinum DDR3 PC12800 Dual Channel 7-7-7-24
- ATI HD3300 onboard (no QE/CI support) :D

Hey, this didn't work for me after upgrading to 10.6.3 and replacing the mach_kernel with this one i get the following kernel panic:

http://img62.imageshack.us/img62/8563/dsc02060a.th.jpg

Using a Phenom II X4 945
Gigabyte GA-MA790X-UD3P

Did you notice that the kernel is for 10.6.2 and not 10.6.3? Wait for a new kernel based on 10.6.3.

Over insanelymac there's a release by qoopz/nawcom of the new 10.3.0 kernel.

Yes, that I'm fully aware of, however i did a clean install, turns out my cpuids that i "fixed" with marvins tool caused a lot of touble, anyhow now i can boot into 10.6.3 just fine with this kernel, I'll check out the new kernel later today:)