InfiniteMac OSx86
Page 3 of 4 < 12 3 4 >
Show 50 post(s) from this thread on one page

InfiniteMac OSx86 (http://infinitemac.com/forum.php)
-   Leopard 10.5 (http://infinitemac.com/forumdisplay.php?f=85)
-   -   GMA 950 stuck at 1024 x 768 (http://infinitemac.com/showthread.php?t=2656)

erick2red 04-27-2009 06:30 PM
i got the stocks kexts, (the one about graphics) from ComboUpd, and then tried with V3 and V4 from that page you referred, didn't work any of those, so go to the patch, to manually create the DSDT.aml myself, and it stop at the point when i had to find "Scope (_SI)" cause my DSDT doesn't have it.

NebKiwi 04-27-2009 06:32 PM
hhmmm
 
That is very weird :/ Well, theres not much I can think of now :(

erick2red 04-27-2009 06:49 PM
let's try this one, send me your DSDT.aml sand a list of what's kexts i had to replace. so i can check against mine.

NebKiwi 04-27-2009 07:33 PM
1 Attachment(s)
Quote:
Originally Posted by erick2red (Post 25401)
let's try this one, send me your DSDT.aml sand a list of what's kexts i had to replace. so i can check against mine.
Ok, no probs.. DSDT is attached... the kexts are as follows..

AppleIntelGMA950GA.plugin version 1.5.36.25
AppleIntelGMA950GLDriver.bundle version 1.5.36.25
AppleIntelGMA950VADriver.bundle 1.5.36.25
AppleIntelIntegratedFramebuffer.kext 1.5.36.25

If all goes well, you should have full res and acceleration..

http://nebkiwi.infinitemac.com/pics/gma950.png

erick2red 04-27-2009 08:31 PM
1 Attachment(s)
This is what i got. When use your dsdt.aml

NebKiwi 04-27-2009 10:17 PM
ok...
 
Can you run the patcher on your hardware and then send me the DSDT.aml? I will attempt to decompile it and add in the neccessary code in, once optimized for your own hardware it should work.. I'm going to get some shut eye now, will do it sometime tomorrow :)

andyvand 04-27-2009 10:32 PM
Quote:
Originally Posted by bhp666 (Post 25116)
You know, i do not know, intel lists the audio as "5.1 channel high definition audio" its on board... but no specs that i can find as of yet...
intel link here my board chip combo is the first column


but OSx86 tools comes up with the following information when i run the "view PCI Device /vendor ID" tool. This is from the Ispci.txt output.

00:1b.0 Audio device [0403]: Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller [8086:27d8] (rev 01)
It contains the following audio controller:
82801G (ICH7 Family) High Definition Audio Controller
You could try a linux codec dump or VoodooHDA (if it works without distorting...)

erick2red 04-28-2009 01:15 PM
1 Attachment(s)
Quote:
Originally Posted by NebKiwi (Post 25433)
Can you run the patcher on your hardware and then send me the DSDT.aml? I will attempt to decompile it and add in the neccessary code in, once optimized for your own hardware it should work.. I'm going to get some shut eye now, will do it sometime tomorrow :)
Here it goes, dsdt.aml and Debug folder that patcher make. I ran "patcher -newHPET", so....take a look, whenever you can.

NebKiwi 04-28-2009 09:41 PM
hmm
 
Hmm, your DSDT doesn't make a lot of sense :/ You have to run the patcher on a boot without any other DSDT's, otherwise the patcher is influenced by info injected on boot, are doing a clear boot? If not, then I am not sure where to go next, I would turn to the experts in DSDT fixes... I would contact Roisoft on insanelymac and send him your DSDT.dsl, see what he makes of it.. sorry buddy.

erick2red 04-28-2009 09:55 PM
1 Attachment(s)
I don't know if i SMBIOSEFi or something else is getting in the middle of my "clear boot", but i can make a boot without dstdt's. Here is.