I just finished building a machine based off the G31M-ES2L and have since discovered that it's a rev. 2, which as many of you know uses a different incompatible brand for the ethernet port. What are the chances this is eventually going to be fixed via software? Initially I had planned to use wireless anyway, but the Rosewill RNX-EasyN1 WI-FI dongle that was recommended to me is painfully slow (perhaps it only has a short range). Could someone recommend another solution that works well ( In both windows 7 and OSx), preferably a USB dongle of some sort, as the space for a PCI card is extremely limited.

Use wi fire
 

its amazyng cheap and works perfect for desktop

http://www.engadget.com/2009/09/02/w...d-impressions/

For some reason the EFI partition never mounts after I run your script. I get this error: _CFGetHostUUIDString: unable to determine UUID for host. Error: 35

I've tried following this guide and this guide as well, but for reasons I assume relate to my Rev. 2 I cannot get my MAC address. If I got into network settings there isn't an ethernet card listed.

Right now i'm booting into SL via chameleon on a usb thumb drive. Has anyone had any luck with this

I'm in the same situation, and when I enter in "1" for my EFI partition it asks for a password, I never set a password when creating the account at login.

I have a Rev 1 board.

Any help.

Thanks

But in my scenario - I can connect to the internet, any help with my situation, when i enter in '1' it asks for a password, whats the password.

I solved that part that I posted two posts above, by creating a password and mounting the EFI, that resolved that Issue. I was able to boot without the CD. Now, just need to work on the audio and graphics driver tomorrow.

Is it fine to update to 10.5.8? Or should I avoid it for now. Thanks

I seem to have everything working fine with this guide except the graphics driver.

I have a geoforce nvidia 7900gs (256mb) card.

i selected it on OsX86 tools and tried to apply it, by even putting in my custom resolution 1680 X 1050, but it still only shows me under display the 1024 X 764 i think it is.

how do I resolve this? Thanks

I installed leopard 10.5.6 yesterday and with the kext attached in the first post system show audio card but it doesn't works. Today i will try to update at 10.5.8, i hope to solve this problem. Someone had this problem?

With my graphic card (xfx nvidia 8600 gts xxx) i'm able to change resolution, but when i change system freeze and i need to reboot manually with power button and when system reboots the new resolution is shown correctly.

My ram are 1066Mhz but system say that are 800mhz, it is a problem?

Did you use the method descripted in the first post to install the graphic card? I think that if the only resolution available is 1024x768 the gpu is not detected correctly.

get the audio kext from this guide

http://an43.com/osx/

those worked for me.

I'm still trying to get my card to work right.

I've update system at 10.5.8 and it works well! Thanks very much :)

Now i would like to understand with system show me that my ram is 800mhz instead 1066...