InfiniteMac OSx86

InfiniteMac OSx86 (http://infinitemac.com/forum.php)
-   Leopard 10.5 (http://infinitemac.com/forumdisplay.php?f=85)
-   -   Installed but with a few problems (http://infinitemac.com/showthread.php?t=114)

Bap 01-28-2008 10:07 PM

Managed to get everything installed with a few problems, booting normally will give me a kernel panic (which i believe to be graphics related). I can boot in safe mode to which it gives me the "Detect your keyboard" screen and then i get through to the "Do you already own a mac" after selecting no, it just hangs there no matter how long i leave it and if im correct the next section is the lan setup wizard, so i think it may have something to do with my onboard dual nic, ive tried it both disabled through bios and enabled and yet it hangs at the same place.

Any help would be greatly appreciated,

Hardware Info:

MSI K9N Ultra (NVIDIAŽ nForce 570 MCP)
Sound: Realtek ALC883
Network: Vitesse VSC8601

AMD x2 4600+
ATI x1800 GTO
2GB Corsair DDR2 6400

kourosh 01-28-2008 11:06 PM

Boot with "Graphics Mode"="640x480x32", it'll skip the whole wizard.

http://osx86.wikidot.com/known-issues#toc9

Always check the wiki.

Bap 01-28-2008 11:07 PM

Sorry i forgot to mention, i have tried booting in 640, it gives me an error saying "This monitor is not supported" or something along those lines

christurner 01-28-2008 11:09 PM

where/ when does it tell you that the monitor is not supported?

Bap 01-28-2008 11:11 PM

After booting in safe mode with the graphics mode in 640, i take it no one has come across this yet?

Bap 01-29-2008 01:53 AM

After trying it again with the network disabled and audio disabled also, in safe mode with 640 graphics mode it says the setup assistant cannot run (as most people say it would skip it allowing me to do what i needed) only when i click ok it just hangs again.

christurner 01-29-2008 09:15 AM

i dont know what to say, thats not what it did for me, i am out of suggestions. sorry mate

Bap 01-29-2008 10:28 AM

looks like ill have to give up and wait untill rev2 is out

cpow85 01-29-2008 11:31 PM

Go into your bios and disable your onboard LAN. Thats what worked for me.

Bap 01-30-2008 02:01 AM

If you read up i already tried that