Help Needed
 

Hi everyone,
Last night i downloaded XxX_x86_10.5.6_Install_Disc_Universal_Final.v2 and burnt it using iso burner onto a dvd rw. So then i booted up and it got as far as:

Darwin/ x86 boot v5.0.172 - Chameleon v1.0.(32 or 22)
Build date 2008-06-09 20:12:22
1022Mb memory (I have 3gigs but took 2 out as i was testing to see if that would work)
VESA v3.6 16 Mb (ATI ATOM BIOS)

hd(126,0) XxX_x86_10.5.6_Install_Disk Universal_Final.v2

Loading darwin x86

and then the pc reboots.


Here is the hardware i have:
1x 320 GB sata II
1x 750 GB sata II
Core i7 2.6 Ghz
3x 1 gig corsair 1300mhz
HIS Radeon 4850 HD graphics card
Airpace pci-e wi fi card
Gigabyte GA-EX58-UD4 REV. 1.0
Sata CDRW+/- DVDRW+/-

Please help!

Thanks
Warren

in your bios settings you should have set ACPI instead of IDE/SATA and then when you get to the same screen, press F8 and type this in:
rd=diskXsY (mine is disk0s2, but it might be different with urs than that) busratio=20 (if you have i7 920, use busratio=22 if you have i7 940, and I use busratio=24 because i have i7 965 EE) cpus=1 (single core) -v -f
then you should be able to boot into after installing, I have to use my Boot DVD XxX 10.5.6 in an IDE DVD drive and using those commands everytime i want to boot up...
p.s make sure you have your HDD/partition set as "First Boot Device" HDD in BIOS. not sure if you use SATA or IDE to boot with...or which i7 your using...

I got mine to install but I seem to have to type that whole line in everytime, I can't use SATA DVD and SATA HDD at same time I had to use IDE DVD to get mine to work, also I cant get LAN - SOUND - GRAPHICS to work yet...let me know if you have those working also.
:)