Gigabyte EP35C-DS3R

[Class]

Hello everyone!

~pcwiz guide: http://www.insanelymac.com/forum/ind...owtopic=121849
~Testing Grounds iPC guide: http://tgrounds.blogspot.com/2009/04...n-your-pc.html

MY SYSTEM
CPU: Intel Q6600
MB: Gigabyte EP35C-DS3R F2 (Rev. ##)
RAM: 1x2GB SAMSUNG DDR2 800MHz
VGA: eVGA GeForce 8600GT 256MB

DOWNLOAD & BURN
Sometimes Linux lies if it is burned right, and also under windows if you have Daemon Tools running, there are some issues, and burning will be roasted, even if during install, the verify says OK.

Use rather ImgBurn in windows, or use it like this under Linux:
http://jdrrant.blogspot.com/2009/01/...-on-linux.html

DISKS
1x SATA Western Digital 200GB
1x PATA Western Digital 160GB
1x PATA LG drive
1x SATA LG drive

I think these are the essential things on installing it. I will try to do so, only to use my ATA cable, with means I have connected an empty WD 160GB HDD and an LG DVD-RW. 1st I tried with my SATA drive, but somehow I get always the message that the disc is damaged....so that why I try it this way now.

BIOS
Prepared my BIOS as~pcwiz's guide sad. Set SATA mode to AHCI, everything else stayed system default.

BOOT DVD
Sometimes I boot with press F8 and type: -v

PARTITIONS
Disk Utility > Erased all partitions > 1 partition > Mac OS Extended (Journaled) > name: OSX
OPTIONS > GUID partition (or MBR)

PATCHES & DRIVERS
VGA > NVinject (256MB)
System > Sata > Intel SATA + AHCI SATA + JMicron
Network > Realtek R1000

INSTALL REPORT - KALYWAY 10.5.1 with ~pcwiz settings
I did everything that was mentioned in the guide, but still, I get always the same: INSTALL FAILED (media damaged)
But what I had to notice, with the same setting, so nothing changed it does not always do the same, but usually it stopped right after the install begins. *Kalyway 10.5.1 and also 10.5.2*


INSTALL REPORT - iDeneb 1.1 & 1.3 & 1.4 with ~pcwiz settings
Which also like randomly stops with this error somewhere on the way, but usually install up to 5-6GB. *tried 1.1 and 1.3* But I got once so close to be done, there was 2 minutes left only, so that would have been around 80% of the installation I believe.
http://farm4.static.flickr.com/3104/246850...b1ca8ac.jpg?v=0

INSTALL REPORT - iATKOS i5 not with ~pcwiz settings
When it comes to install my HDD makes 2 knick-knock sounds, then install fails
http://farm4.static.flickr.com/3104/246850...b1ca8ac.jpg?v=0

INSTALL REPORT - JaS 10.8.4 not guide used
Installs fine, goes upto 100%!

Then with the 1st boot this:


BOOTING
Couldn't boot yet any distributions.

SOLUTION
NOT FOUND YET!

QUESTION & HELP
WTF is wrong? ...obviously something "special", since I did everything what the guide did say. Is the LG dvd recorder the problem?