Acer Aspire 5735z Install Iatkos s3 v2 Help

[hassan]

Hi guys, I've been at this for about 2 days. I tried using the retail edition of snow leopard, then I moved onto iatkos. Anyway,

Install process was a hit and miss, sometimes it would load (take 5 minutes) if I used the above options, sometimes install wouldn't load at all (even if I used those options or nothing at all), If I used no options, it would stay on the grey screen with no animations. If I did the options it would take a while before going to the install screen. And even then, sometimes the touchpad would be unresponsive.

I left the kernel on default, installed the drivers for the ethernet, wireless and left the VGA unchecked. AFter installation finished and rebooted, I first tried booting with any options, it wouldn't boot. I then tried it with the above flags that I used when trying to get the installer to run, it would take about 5 minutes and give the following kernel panic error



I would like to start again, maybe get install to run smoothly and choose the correct settings. I have an acer 5735z, here are the specs taken from everest ultimate edition

CPU Type Mobile DualCore Intel Pentium T4200, 2000 MHz (10 x 200)
Instruction Set x86, x86-64, MMX, SSE, SSE2, SSE3, SSSE3
Min / Max CPU Multiplier 6x / 10x

Front Side Bus Properties
Bus Type Intel AGTL+
Bus Width 64-bit
Real Clock 200 MHz (QDR)
Effective Clock 800 MHz

Mobile Intel(R) GMA 4500MHD
Video Adapter Intel GL40/GM45/GM47/GS45 Chipset - Graphics Controller 0 [B-3]

Wireless: Atheros AR5009 802.11a/g/n Wireless Network Adapter
Ethernet: Marvell Yukon 88E8071 PCI-E Gigabit Ethernet Controller
Audio: Realtek ALC268 @ Intel 82801IB ICH9

Any help would be appreciated. Oh and I'm installing on an External IDE hard drive