Tulip.kext

[compaqdrew]

## Automatic notice to thread opener:
If you post this kind of message into the News Category again, your Account will be disabled

I picked up a NetworkEverywhere NC100U-WM from wal-mart, as my onboard nForce ethernets don't work. The card has been working with Tulip in the past.

I compiled Tulip with XCode on my real Mac, then loaded it. It seems to run ok, I get a message at boot:

darwin_tulip_admtek985: Ethernet address: BLAH

Yet it doesn't show up in network preferences. Any thoughts?

--Drew

[roisoft]

Open Nerwork preferences and click over "+" and add the ethernet adaptor..