InfiniteMac OSx86  


Reply
 
Thread tools Display modes
  #1  
Old 10-18-2012, 06:33 PM
phsilver phsilver is offline
Cheetah
 
Join Date: Jun 2012
Posts: 3
Network Configuration

Hello...

I have a RTL8139 network card.
Lion recognizes it perfectly, but when I try to configure it with an authomatic DCHP, it gives me a wrong IP address and wrong Submask...

If I try to configure it manually, I can't get connection.
When I run the Diagnosis, I got the first 3 lights on green, but red in the two last...
I try everything: put DNS and Gateway and so on...

This is what I'm talking about:


Does anybody got a clue???
Thanx in advance!!!
Reply With Quote
  #2  
Old 12-31-2012, 12:44 AM
unimatrix725 unimatrix725 is offline
Cheetah
 
Join Date: Jan 2011
Posts: 1
Talking Cannot Guarantee but...

I know you siad you set it manually. Have you tried to set your Ethernet Manually with set link speed 10 and/or 100 with and without half/full duplex. I have a different card and had to use 100 Full Duplex, with static ip, subnet and gateway.
There is a small possibility that your ethernet cable will not support 1GB or 100MB even. This can be from interference, kinks/shorts, crappy quality, even length. If you had Snow Leo or another OS with same hardware then I would say....

There may also be an issue with the "network driver" (aka kext), this may help:
http://www.osx86.net/view/378-realtek_rtl8139.html . If you want to go a harder way (more reliable) use a EFI string and put BuiltInEthernet=No in your chameleon boot.plist.
I hope this helps you!


Reply With Quote