Hello there,
Here is my problem:
I boot for the first time, I installed iDeneb v1.3 10.5.5 on a USB key by booting with the CD Drive. So, I boot with the CD, otherwise, I see the Apple logo and then the computer shuts off.
Here is my boot flag. From the iDeneb's CD.
After, it boots after a little bit of time.

Here is what I see:
Before you can start:
Configuring the keyboard. Then I click "Continue" I type "ù" as they ask for my keyboard and then I type "é" as they ask for my keyboard. Then it gives me its guess (USA keyboard or Canadian keyboard) I agree with it. Then I put my time zone which is CSA (French Canadian). I press "Continue" and then here goes the problem. Backup datas from a Mac. I press "Don't transfer any data" I press "Continue" and then the computer goes for a while with the USB Flash Memory LED blinking and then it goes back with the keyboard information... Until I turn off the computer, because I cannot do anything anyways.

Here is what I want to do.
I looked for putting iDeneb's iso onto my USB Key, but it doesn't seem to work without a Mac, and I dont actually have a Mac. So I wanted to install it to a USB Key for the moment so that I can make my iDeneb ISO to another USB Key that's big enough too. Why do I do this? Because my power supply only have one (1) IDE power chord. iDeneb doesn't detect my SATA hard drive disk and when I boot from a SATA DVD Reader, it gives me:
So I wanna install Mac to USB Key firstly so that I can put the ISO onto another USB Key, to install it on another IDE Hard drive!

Thanks!