PDA

View Full Version : Not booting after instalation

billguerra
12-25-2009, 10:17 PM
DELL XP 400

I have installed ideneb 10.5.7 was running good but I installed windows over it by mistake and restore my bios to factory defaults now when I try to reinstall again the installation goes fine and after restart only apple logo no smoke ring, I have two HD installed one has windows 7.

processor Intel p 4
cache 1MB 0r 2 MB
memory 4 GB
chipset intel 945P
bioss chip (NVRAM) 4MB

Thanks
Imkantus
12-30-2009, 02:09 AM
Did you made the selection of one of the included patched Kernels?
xmath279
02-01-2010, 12:33 AM
You don't have the smoke ring... But does the computer stay on? I have the same issue but the computer goes off... Maybe it's your problem... Anyways, for booting I booted from the CD with the flag rd=disk0s2 (to modify by your installation hard drive). Or if you cannot boot to the CD drive, you could try -v -x. Also, you can modify SATA settings in the bios to AHCI.