Zephyroth / Kalyway - installing on AMD problems

Gigabyte M57SLI-S4

http://www.gigabyte.com.tw/Products/Motherboard/Product… ↗

(here are the chipset specs , or you can look at the link above):
1. NVIDIA® nForce 570-SLI
2. Super I/O: ITE IT8716 chip.
3. Integrated Peripherals
1. T.I. IEEE1394 controller
2. Marvell 88E1116 Gigabit Ethernet controller
3. Realtek ALC883 Audio Codec

Another thing, zephyroth since (i guess) its your version the Zephyroth release , i found a post somewhere on how to make Zephyroth boot after restart, but it requires me to enter -s mode when booting from DVD...the problem is i have a ps2 keyboard, which wont work in -s mode (didnt work in the install either, luckily i didnt really need it)...any help with this?

well i installed again Zephyroth 10.5.2 rev 2, because i did miss something yesterday...i didnt choose MBR within DiskUtility when installing Leopard. Today i chose it, i isntalled the MBR Boot Loader , but still my Leopard wont boot.

Can anyone at least give me a hint what to do to boot leopard from hdd? I tried adding it to my Vista Boot loader but actually my hdd is not seen by vista for some strange reason... --- actually it is only seen in Vista`s Disk management, not as a drive (d,e,f etc) in windows explorer , so i cannot choose to boot from it from within the vista boot loader

thanks a bunch zuz242, i will look into all of the things you said...

for a specific hdd boot, i dont think it was the case because i only had my Leopard hdd and my dvdrw active when i installed and when i restarted, so only 1 hdd and still didnt work. if i make it 'active' the partition (actually the whole hdd since there is only 1 partition on it), wont it screw with my vista/xp installations? right now the partition with Vista is marked as ACTIVE

ok so finally it DID boot after restart (im not sure what i did )…now..of course..another issue
Loading Leopard takes like A LOT...as im writing this , i have been waiting about6-7 minutes...and im just at a black screen with the spinning-wheel-mouse-cursor on it...and still waiting (since there is still hard disk activity)...

any tips for makin it run faster?

edit: it stopped loading from hdd, still the same black screen…strange thing..when i right-click, i get hdd activity...

"Still waiting for root device ..." error is related to the chipset of your motherboard.
What's your mb ?

i dont know for sure, but installation on sata could be problematic
any chance for u to install on an external disk as a test?

did you check the (two) wiki? it got good info on installation issues.

the easiest way to boot from a specific hdd is using the bios bootloader
(depending in mobo, but most got this option, at f8 in my case)

on "dualbooting", read the wiki´s and search for easybcd for adding to vistas bootloader.

i case you already got your hdd choosen at bootup and osx /darwin bootloader
wont show, read the wiki about "making partition active" "blinking coursor"
and "installing efi-bootloader"

good luck

try booting with "-v", it toogles verbose mode, showing log/terminal output while stystem start.
this should give you a clue where the problem is

Hey eemerge, I hope things are finally working for you, after installing Leo4Allv3. =)