I finally got my desktop to run iPC OSx86.
It's installed on an external hard disk. I have to boot up with -v -f or it doesn't work though.

A few issues/questions:
1. System Information shows that QE is not supported and CI is software only. My graphics card, GeForce 8500GT should support QE/CI according to the HCL. What can I do to get this to work?
2. My external hard drive that I'm running OSX off is basically an IDE hard disk in an external USB enclosure. I have one other IDE har drive(internal) that I'm running XP on. If i just pull the IDE hard disk out of the enclosure and put it internally as IDE, can I set up a dual boot or do I need to reinstall iPC all over again?
3.My IDE drive(NTFS) did not show up inside OSX while my SATA drive(FAT32) did.How do I check if this is because if not recognizing IDE or not recognizing NTFS, because I did select NTFS-3G-Fuse at install.
4. Any chance there's a way I could lose the -v -f at boot up. Doesn't matter if I can't but it would be nice that's all.

Any help is greatly appreciated. This forum is why I got this far in the first place. So thanks everyone.

---

Desktop:
AMD Athlon 64 3000+
MSI RS482M2 Motherboard
2GB DDR400 RAM
1x 80 GB IDE HDD
2x 120GB SATA HDDs
Creative Audigy Sound Card
GeForce 8500GT PCI-e Card

Laptop:
CPU
AMD Turion 64 X2 Mobile TL-50 (Socket S1 638), Codename: Taylor,
Cores: 2, Instructions: MMX, 3DNow, SSE, SSE2, SSE3, x86-64
Motherboard
Quanta 30B7
Chipset: Nvidia GeForce 6150
Southbridge: Nvidia nForce 410/430 MCP
Memory
4GB Dual Channel DDR2 RAM
Sound
Conexant HD Audio