"Waiting for Boot Device with UUID..." Help me Please!

[Perception]

OK guys, heres the scenario. I built a media computer for my home, and wasn't exactly planning to install OSX86 on it, my first mistake, i know, since I didnt plan the hardware accordingly.

My first motherboard gave me a "still waiting for root device" constantly, so I sold it and swapped it out for this new mobo... the Biostar TA790GX XE...its a mATX board, and I purchased it because the main OSX86 wiki claimed that a board in the same series worked "with no patching" etc etc....last time I listen to the damn wiki.

This board has the 790GX and SB750 chipsets.

Also for compatibility reasons, I bought a nVidia 9400GT instead of using the onboard graphics, because I had been getting this "Waiting for boot volume with UUID...." error (as listed in my title) and much reading online suggested that the video card may very well be the problem.

Here I am, at least 3 weeks later and I'm seriously about to jump off a bridge...this thing is driving me nuts! No matter what I do, I can't get past this "UUID" error.

I promise you, I've read EXTENSIVELY on what I can do...switched from AHCI to Native IDE and back 100 times, swapped Master/Slave settings for the HDD and Optical over and over, bought a new video card, entered all the boot flags, tried safe mode, tried to specify the root disk!

I'm just out of ideas, and i'm not very keen on running Windows anymore...I've had a taste of OSX with my other hackintosh, and I just don't really want to go back. Yes, I have done this before on another machine, which I also had to painstakingly troubleshoot, but everything was working in the end.

On this new machine, I can't even get the install disk to run so I CAN troubleshoot any issues that arise.

Please, any help would be greatly appreciated, I'll try any suggestion you have, I just want to get this thing crackin'.


Peace,

P

[TheHAWKs]

im not sure what distro "ideneb, IPC, XxX" your using but you must make sure it has drivers for your North and South Bridge. you probably did not pick the right Drivers if the DVD boots but fails to boot after install.

[Perception]

HAWKs,

thanks for the reply, your input is appreciated. I have tried iDeneb, XxX, and iPC all with no luck, but it's not that the osx installs and then I cant boot, the problem is the osx disk wont even install...it just stops on this "still waiting for boot device with UUID.."

Any ideas about this? Is there a way to incorporate the drivers for my north & south bridge into a distro and then re-burn it?


P

[Perception]

Not only that, but if that's the only solution, does anybody know where to find drivers for the 790GX and SB750??

[Aydinz]

hmm, sounds weird. getting a still waiting for root device error, have you made sure that the hdd with mac os x has chameleon bootloader on it and it is set as the active partition?

[Perception]

Ok everyone hold on a second....I don't think I'm getting my problem across correctly...

the error i'm getting is "Waiting for boot volume with UUID...." not "still waiting for root device"

Also, I can't get chameleon set up on the disk, because the install DVD won't even load so I can install OSX...I never even get to the point where I reboot into OSX for the first time, because all 3 distro's I've tried using (iPC, XxX, iDeneb) have failed to install OSX because they get stuck at that error, listed above.

[Voyn1x]

Hmm, it sounds like you've tried most things.

You could always try bypassing the dvd completely by burning the image to a usb flash drive:

http://www.infinitemac.com/f5/how-ca...ac-os-x-t1448/

Good luck, remember it's all worth it in the end!!

[zuz242]

Originally Posted by Voyn1x Hmm, it sounds like you've tried most things. You could always try bypassing the dvd completely by burning the image to a usb flash drive: http://www.infinitemac.com/f5/how-ca...ac-os-x-t1448/ Good luck, remember it's all worth it in the end!!

yup, if dvd won´t load, it is missing the chipset drivers. putting the install dvd on a bootable usb stick avoids that. -> http://osx86.wikidot.com/en:how-to-s#toc12
but an already running osx system is needed for that.

otherwise you could try to inject your drivers in a distro dvd, which is somewhat difficult (havn´t tried it myself ..)

or you could try other distros, if they incorporate you chipset driver. (maybe the lawless one?)

[Perception]

Thank you everyone for the replies, hopefully I can get a solution worked out of this whole thing.

So let me get this straight, I can use the USB thumb-drive method and bypass these problems as long as I already have an OSX environment?

Even I think this is a stupid question, but do I have to have a previous OSX install on the computer I'm trying to install on, or can I use my other haxintosh, or someone elses mac, etc etc?

Thanks again to you all...

[Voyn1x]

Any OSX install, you only need access to disk utility.